Tears of my Enemy Ghost

This design is available for free for personal use only.

Check out my membership on Patreon, Thangs, or MyMiniFactory for more designs.

Painted 3MF included. Verify your settings, including flush settings. If you have issues with the straw, slow down your acceleration. 

Printing recommendations: 

• Straw needs a brim - everything else is printed in place. 
• Initial Layer and Infill Speed - 25 mm/s Line width has been changed to .3 to help with details of the juice box. 
• .20 layer height 
• Print in place, no support required 
• 3 walls - 10-15% infill 
• Allow the plate to cool before removing the prints 
• Slow Printer Acceleration for smoother prints - Half speed on the outer wall creates smoother prints

Looking for more designs? 🛍️ Browse the full collection in the Rebel Alicorn MMF Store

⚠️ Important – Please Read: All Rebel Alicorn Designs are protected under Copyright Law.

Your purchase grants you the right to download and print the design for personal use only. You do not have permission to: Resell, Remix, Alter, or Redistribute the digital files in any form

No design modifications are allowed. Except for keyring holes and straw holes, other changes must be approved.

Selling physical prints of any Rebel Alicorn design requires authorization. To become an authorized seller, you must join the “Merchant Tier” on Patreon, Thangs, or MMF.

⚠️ Safety Warning: These designs are not suitable for unsupervised play by children or pets. Broken or rough-played 3D prints may produce sharp edges or small parts that can pose a choking hazard. Not recommended for children under age 5.