Philadelphia Eagles Keychain

Go Birds!

Just a simple Philadelphia Eagles logo in keychain form. This prints face down and the image is not on both sides. I wanted to reduce filament waste and print time, but let me know if there's a desire for double sided and I can add a print profile. 

I'm new to modeling, so feel free to adapt and share your improvements! 

If you do adjust size, I recommend not adjusting the z values, especially if you're reducing the size. It's currently 2mm. Any thinner and I don't think it would be thick enough for a sturdy keychain. Increasing the z value is fine if you want something thicker, but it will add another layer of the logo image, causing more filament changes, and consequently more filament waste, so just something to keep in mind.

Sell at your own risk - the NFL might care but I do not. I just ask that you share your creations and give feedback!

Enjoy!