Jade Rabbit Holding Moon Lantern

Printing Notes:

1. Due to the thinness of the model, there isn't much support. To achieve a good print, it's best to ensure the filament status and parameters beforehand
2. I used white PLA, which has good light transmission. If you want to use other colors and materials, please try them yourself

Assembly Notes:

1. The model only has a subtle support on the bottom and one internal support, requiring small pliers for removal as it may be difficult to remove by hand
2. For the internal lighting, I used an LED strip. It is installed later; a bottom slot has been set up. First, insert the light vertically into the round piece, then place the LED strip into the rabbit's body, and finally snap it into the bottom circular groove. If you want to remove the light, simply press the light holder firmly inwards, then use your hand to pry out the slot, and the light can be taken out. The LED strip & slot are shown in the figure:

     3. If you want to use other lights, you can leave a message and provide the dimensions, and I can design a corresponding slot for you to use

     4. A hole is left on top of the rabbit's head for tying a string, please tie it before inserting the light

     5. A model of a star-shaped rod is also provided, which can be used to carry the lantern. As shown in the figure:

Note: I am not a professional modeler, I do this out of interest. If you have any questions, feel free to ask. I hope everyone enjoys printing~