Search models, users, collections, and posts
Neewer TL96RGB Cold Shoe Mount
IP Report
This model is created by Parametric Model Maker
Make Your Model
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
37 min
1 plate
Open in Bambu Studio
Boost
3
9
0
1
8
2
Released
Bill of Materials
List other parts
- 1/4" screws x 2: I recommend metal screws, but you can also 3D print them
Description
Use this model to attach your Neewer TL96RGB light to your camera or other cold shoe mount.
You'll need some ¼" screws to attach the light to the mount. You could buy them online or print these: https://makerworld.com/en/models/999551-1-4-inch-photo-camera-tripod-thumb-screw (be cautious though, as one of mine broke after turning it too tight, leaving the screw part inside of the screw hole…)
If you like what I did, consider a like or a comment with a picture of your print in action! I'd really appreciate it :)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)