Search models, users, collections, and posts
Tool Shop 10in Miter to 2.5in DeWalt Vac Adapter
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
4
34
2
0
37
25
Released
Description
- Fits Tool Shop 10″ sliding miter saw – model 2402093
May fit other Tool Shop models but I can't say for sure. The OD of the dust port on my saw measured 1.738″ but was slightly uneven due to being cast. I used calipers not a micrometer to measure so there's also that.
I made the adapter’s ID on the saw side 1.740″, It's a snug friction fit, won't fall off. It bottoms out on the lip inside the adapter, not the saw itself, hoping it will help it seal well. - Connects to DeWalt 2.5″ shop vac hoses with a snug slip fit
- Clean tapers and round overs on the interior for smooth, un-restricted airflow
- Minimal support required
- Recommend printing in PETG or ASA for heat and impact resistance
This part was modeled and tested in PETG. You may need to scale slightly to account for material shrinkage if printing in other filaments. - Designed with fast printing and efficient filament used in mind
- As with all my prints its strong and over built and should hold up to hard use.
Boost Me (for free)
I hope you find this helpful! if you do please like and leave a comment. A boost is always appreciated too!
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)