TRON Battle God Motorcycle

Super glue needed! Super glue needed!! Super glue needed!!!

I made this model based on the "Tron" movie promotion; there was no complete reference, so I personally believe the similarity is 85%. This is a personal hobby; if you have any questions, please communicate kindly.

Some colors are missing, so I have recolored all printed parts according to the required color scheme. When printing, try to apply glue to prevent the build plate from detaching.

Please refer to the following image for assembly instructions:

Glue the above parts as shown in the image below.

Then assemble the parts according to the pictures.

Insert part number 1 as shown below; do not glue it in this step.

The following steps can be glued first.

In the step below, the seat bracket and body position are not glued first, for later use.

Glue the wheel covers as shown below.

Remove the top cover of the silver part, push the wheel covers from both sides into the lower protrusion of the silver part. Glue them together.

Close the top cover, glue the top cover to the wheel covers. The wheel covers themselves are also glued left and right.

Install the side brackets and wheel mounts.

Assemble the rear wheel cover into left and right sides using the same operation.

Remove the seat bracket, and glue the rear wheel assembly and frame.

First, glue the side bracket and body bracket.

Then install and glue the entire rear wheel assembly.

Reinstall the seat and glue on the mudguards.

Glue the handlebars and wheel cover accessories.

Finally, take a photo.