Search models, users, collections, and posts
Forge Intercooler Stencil
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
2 plates
Open in Bambu Studio
Boost
2
4
0
0
2
0
Released
Description
Made a stencil for my forge intercooler, didn't want to wait for shipping. Prints in two pieces and then I used hot glue to tack the corners down during painting. The quality of the stencil depends on how well you mask with tape and how much glue you use to tack the edges down.
Wait until the build plate is completely cool before pulling off to minimize effects of warping
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)