Lure bait, Zigzag dog,

Materials needed:

This model requires two treble hooks, 1mm bracelet beads (for rattles), solder wire or lead sheet (for weighting), 0.8-1.0 steel wire (or 1cm eye pins), and super glue. To achieve the smoothness of my model, you will also need UV resin; just apply and cure.
The operation process is as follows:

1. First, insert the pin,

2. Take two 3cm lead wires and insert them into the left and right molds respectively.
3. Apply glue to one side of the mold, insert the baffle, and insert the rattle bead. Close the mold and fix it.

3. Use needle-nose pliers to curl 4 eye pins (2 separate, 2 joined together to connect the tail). Note (this step can be replaced by pre-made eye pins).

4. Use a windproof lighter to heat the eye pin handle until red hot and directly insert it into the reserved hole (for pre-made eye pins, apply glue and screw directly in).

5. Apply UV resin and cure for coloring (this step can be omitted).

6. Attach treble hooks with fishing pliers (the tail can be removed and replaced with a treble hook).