Search models, users, collections, and posts
Basic 35 pt Toploader Badge Holder (PLA)
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 5% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
21
39
6
1
39
20
Released
Description
Wear your trading card like a badge. Perfect to wear at card shows or a simple way of displaying cards.
I used PLA Filament in Gold Color.
Dimensions:
3D Print Holder Dimensions: 81x5x110 mm
Lanyard Measurements I used:
Braided Cord is 457.2 mm long
Metal Holder is approximately 50.8 mm
Instructions
1. Simply insert your card in penny sleeve then toploader (35 pt).
2. Then insert the top loader into the 3D printed holder.
3. Insert your lanyard clip into the hole located at the top center of the holder.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)