Search models, users, collections, and posts
Kenworth 963 Bed
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
35.2 h
15 plates
Open in Bambu Studio
Boost
10
26
3
0
6
2
Released
Bill of Materials
Maker's Supply Kits and Parts
Select all
Bambu Filaments
Select all
Description
This is an upgraded bed for my Kenworth 963 model. It’s now wide and long enough to fit two 1/10-scale crawlers side by side, and it also includes sliding ramps so you can load 1/18-scale crawlers on the ramps as well.
For the sides and back of the bed, I recommend using 5 mm × 450 mm rods — you can get them here: https://amzn.to/42MsZ0E.
It also requires eight 50 mm-long sections, which can be made from the offcuts of the five rods.
Just a heads-up — the link above is an Amazon affiliate link, so I might earn a small commission if you pick something up through it (at no extra cost to you).
Special thanks to Black Crow (Rocky Top) for all the help
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)