makita makpac clip
Print Profile(1)
Bill of Materials
Description
Makpac Clip that is routed in
The board I used is 56x39 cm (19mm)
Printed with PETG
Minimal supports that need to be removed
Align the cases on the board and mark the center of the pins
Stick on the routing template with double-sided tape using the markings
For routing, I used an 8mm flush trim router bit with a top bearing
After routing, first insert the shell without the clip into the recess and pre-drill with, for example, a 2mm drill bit
Remove again and assemble the two parts (you might need to sand the round pin a little)
Assembly is a bit difficult, but it works
I used 3.5x25 screws, which are screwed in a bit diagonally with a long bit, and I also used a little assembly adhesive
The clips have a snap-in point in the housing so that they only open when intended
I only use this for transport if someone really needs it to be stable, you should mill all 4 per case and the board would also need to be a bit larger…
But I tested it a bit and it held surprisingly well
You can also find the mounting for the board on the Flex Stack Pack System on my profile
I always appreciate feedback or a boost :)
Boost Me (for free)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (16)