Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 100% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
3
6
0
0
9
0
Released
Description
Content has been automatically translated.
Ninebot charging port modified to XT90 interface,
A bracket, the original cable can be used, same as mine,
Should be usable for mz, m, n, m3, m5 series, and lead-acid battery models.
Others are unknown, check if it's the same as your original vehicle.
XT90 male and female should both work, haven't tried female.
The original charging port cover is of good quality and elasticity, just pull it off with something and install it on this modified model.
My print is a bit rough, the filament is a bit damp, do your own research.
Adjust the inner diameter compensation based on filament shrinkage; a slightly smaller outer diameter doesn't matter.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)