Search models, users, collections, and posts
Corner Clamp Adapters for Jorgensen EZ-Hold Clamps
IP Report
Print Profile(2)
PETG 0.2mm layer, 4 walls, 12% infill
Designer
1.2 h
1 plate
Jorgensen 33804 4" Clamp - 0.2mm layer, 4 walls, 15% infill
1.5 h
1 plate
Open in Bambu Studio
Boost
21
99
6
7
90
60
Released
Description
Boost Me (for free)
It's Free!
Corner Clamp adapters for Jorgensen EZ-Hold squeeze clamps. These can help with miter alignment or helping with drawer boxes. They're intentionally slightly oversized as I found there was slight variations in how snugly they fit to each clamp. Adding tape to the face of the clamp (as depicted) can help dial in the fit.
Recommend PETG but PLA can probably be used without issue.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (6)