Type 2 EV electric car cable holder

Update:

Following some feedback, I have uploaded the print profile for a test ring (approximately 10 min print time)

It is highly recommended to print the test ring as many Type 2 adapters have slightly smaller or larger dimensions and might not fit into the holder

I have also reduced the print time of the holder by about 1 hour

The print has now been scaled to 102% as it was slightly tight and inserting the connector was difficult

Procedure (recommended):

1. Print the test ring and insert the connector

1. If the ring is too tight or loose, scale the ring by percentage until it fits correctly (it should be able to move freely)
2. Print the connector profile scaled by the same value as the ring

Description:

Holder for Type 2 electric car charging cable

There are two print profiles. One with a flat version and one angled for a longer cable. The plug releases by gently lifting the handle before pulling it out

This thing was created by BWThompson, and is licensed under Creative Commons - Attribution

🙏 If my designs brighten up your day, you can support my work by giving me a free boost. Your support is invaluable! Thank you!

If you’d just like to make a one-off donation, you can buy me a coffee here ;)

https://buymeacoffee.com/byphildesign