Snowman – Two Variants - No AMS

⛄Snowman – Two Variants

He stands there as if freshly rolled from the snow
A wide smile on his face, the scarf neatly arranged, the top hat perfectly in place – ready for winter, Christmas, and good cheer
Whether on the desk, on the shelf, or next to the Christmas tree – this little snowman immediately brings back the feeling of cold air, warm light, and quiet days
A simple yet lovingly crafted decorative model that spreads winter cheer no matter where it stands
With a little patience during assembly, a small companion emerges that looks almost as if it were sculpted directly from snow

Sizes:
• Small: approx 9 cm tall
• Medium: approx 13.5 cm tall

• Large: approx 19 cm tall

Variants:

There are two versions of the snowman:
1️⃣ With branches as arms – classic and natural
2️⃣ With gloves – a bit more playful and rounded in appearance

Both variants are identical in construction and size; they differ only in arm design

Assembly

• Variant 1 (Branches):
  The branches are simply inserted into the designated openings on the body
  They can be fixed with a small drop of superglue, but it's not necessary – the fit is snug enough that they hold well without glue
• Variant 2 (Gloves):
  Before gluing, the contact surfaces of the gloves and body should be lightly deburred and cleanly finished so that they sit flush
  When glued correctly, an almost invisible connection is created – completely without a gap

Details & Assembly

• The scarf is the same for both variants
  Before gluing, dry fit once to ensure all transitions close neatly
  The hanging part of the scarf is aligned with the small recess on the body
• Eyes and Buttons:
  These parts are arranged separately on the print plate and are slightly different in size – this is intentional and creates a more natural expression
  It's best to apply a small amount of superglue directly to the body, carefully place the eyes or buttons, align them, and press lightly
• Mouth:
  Here, it is advisable to apply the superglue precisely to the head with a toothpick
  Then position the mouth like the eyes and buttons and press firmly

Print Tip

The white elements are set up by default with 4 wall lines and 1% less infill
This prevents the white from shining through in strong light
White filament is often slightly transparent – this setting compensates for that without enormously increasing material consumption
Anyone who wants to can adjust the wall thickness, but it is not necessary – the balance is chosen so that the model appears stable, clean, and optically solid

The models are designed so that all parts are cleanly printable and, after assembly, appear as if they were made from a single piece – round, clean, and high-quality in appearance

More Models: