Articulated Grem - Gigi Murin Gremurin

GIII MURINNNN! 

This is a Print-in-Place articulated model of Hololive V-Tuber Gigi Murin's fan mascot the Gremurin (a.k.a. Grem)!

The model features a 4-segment articulated body and tail with 4 widdle paws. The articulation is designed to maximize whimsy; the Grem's tail can curl up and down and a little bit to the left and right. The face and tail details are included in the model, whereas the stripes and belly are colored in using Bambu studio.

There are two sizes available for the print profiles. feel free to change the scale if desired

1. Standard size
   • Length: 75.19mm 
   • Width: 28.81mm
   • Height: 12.34mm
2. “Grembo”
   • Length: 321.96mm (over a foot long!)
   • Width: 123.37mm
   • Height: 52.84mm

*Note: after printing the standard sized Grem, the paws may need to be “broken” in by bending them back and forth a few times. After that, they should break loose and be good to go! I haven't tried printing at other scales yet, so if you try and have any tips, feel free to share in the comments

Printer used: Bambu Lab X1C

Filament used:

• Yellow: Bambu PLA Basic - Sunflower Yellow (10402)
• White: Bambu PLA Basic - Jade White (10100)
• Black: Bambu PLA Basic - Black (10101)
• Brown: Bambu PLA Matte - Dark Brown (11801)
• Orange: Bambu PLA Basic - Pumpkin Orange (10301)

Here are some details about each of the print profiles included:

• Grem-5Color: 
  • Standard size
  • 5 colors (Yellow, black, white, brown, and orange) are used to faithfully bring to life the classic design of the grem.
  • A dual AMS with AMS hub setup was used to print with all 5
  • Completely print in place with no supports necessary
• Grembo-5Color:
  • "Grembo" size
  • 5 colors (Yellow, black, white, brown, and orange)
  • A dual AMS with AMS hub setup was used to print with all 5
  • Some supports are included to help with the overhangs in the joints, nothing crazy though, and they come off easy
  • This is the profile used to print the large grems as seen in the pictures. 
• GremTray-5Color:
  • 22x Standard sized Grems
  • 5 colors (Yellow, black, white, brown, and orange) are used to faithfully bring to life the classic design of the grem.
  • A dual AMS with AMS hub setup was used to print with all 5
  • This is the profile used to print all the grems as seen in the pictures.
• *If you only have one AMS, the stripes can be switched out with Black in Bambu Studio to allow for 4-color printing.

If you end up printing one of these lil goobers I WOULD LOVE TO SEE IT!!!!! Please comment here or tag me on Twitter! (@Finn__128)

Feel free to reach out to me with any questions or requests!