Magnetic phone holder compatible with Magsafe magnetic charging, beautiful, minimalist, and practical above all else~

As seen in the picture. Very practical, simple and good-looking

The model is based on the iPad tablet stand I designed, combined with the MagSafe stand I made before, and modified from them. It is very practical, simple and good-looking

• Direct link: Same style iPad tablet stand (click to view) original MagSafe stand (click to view)

print profile introduction

• Can be used as a MagSafe magnetic charging base. You can also use the handmade magnetic ring I provide, just as a simple stand

The model will prompt for floating, no need to worry about it, no need to enable supports. There are some overhangs on top, just scrape them off with a knife

• Three angles, ergonomic, very comfortable to use
• Easy to print without supports
• Four versions have been iterated, many details have been optimized

Required materials for handmade MagSafe magnetic ring

• 20 pieces of 4*2mm round magnets (there are 20 installation slots, fully loaded, the magnetic force is no less than the original)

These magnets are from the official syberbrick set, which I just happened to use. That's why this size was used. I searched, and they are also super cheap, but the magnets I bought on Taobao are not as strong as Bambu Lab's official magnets, you get what you pay for. So I only guarantee that the magnetic rings made with Bambu Lab's magnets will have sufficient magnetic force~~~

Pay attention to the direction when installing magnets, will update later