Zenless Zone Zero Yun Kui Shan Fridge Magnet

Zenless Zone Zero Yun Kui Shan, the fridge magnet has five magnets embedded, no multi-color system needed

I personally used PETG material, but I think PLA would perform better, I hope someone can print it and share pictures, haha

When sealing the layer after inserting the magnets, there might be some stringing around the magnet holes that doesn't seal completely, you can ignore it as it will be covered normally after a few layers and will not affect the normal printing effect.

The model size is 57.54x80mm, and the actual thickness of the physical object is 5.68mm

    Pause at layer 33 and insert five 10*2mm magnets. If five magnets are too many, you can reduce them by deleting the cylindrical holes you don't need.
    Pause at layer #43 (3.52mm) to change to red
    Pause at layer #52 (4.24mm) to change to yellow
    Pause at layer #66 (5.36mm) to change to white, for highlighting. You can also choose not to change it; pure yellow also looks quite good.