dressyspider

cover

2025-11-20_nr4g165j3ha8.jpeg

plate_1.png

2025-11-20_axjamfl4npl9.jpeg

Sliced for PLA using the 0.20 mm Standard Bambu Lab profile for X1C. Only the following settings were changed from the default profile; all other values remain at Bambu Lab defaults.&nbsp;&nbsp;Speed<ul><li>Initial layer speed set to 50 mm/s</li><li>Initial layer infill speed set to 50 mm/s</li><li>Outer wall speed set to 100 mm/s</li><li>Inner wall speed set to 150 mm/s</li><li>Small perimeters speed set to 50%</li><li>Sparse infill speed set to 150 mm/s</li><li>Internal solid infill speed set to 150 mm/s</li><li>Vertical shell speed set to 80%</li><li>Top surface speed set to 150 mm/s</li><li>Slow down for overhangs enabled</li></ul>

50 mm/s - 0.2mm layer, 2 walls, 15% infill

https://www.printables.com/model/336374

https://www.printables.com/model/103318

A lightweight remix of <a target="_blank" rel="noopener noreferrer ugc" href="https://www.printables.com/model/103318-snowflake-x-wing-kit-card-christmas-ornament">basti30’s Snowflake X-Wing kit card</a>, inspired by the lightweight approach from <a target="_blank" rel="noopener noreferrer ugc" href="https://www.printables.com/model/336378-snowflake-tie-fighter-faster-print">TomasC</a>. The goal was to speed up print time, use less material, and keep it perfect for slipping into a card as a small kit.&nbsp;Remix notes<ul><li>Geometry adjusted to print faster with less material</li><li>Keeps the overall look and feel of the original design</li><li>Still prints flat as a single kit card with no supports required</li></ul>

Snowflake X-Wing Kit Card Ornament (Light)

ASIA

Print Profile(1)

Description

Comment & Rating (2)

This remix is based on

License

Related Models