Search models, users, collections, and posts
Print Profile(1)
0.18mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
2
2
0
0
8
7
Released
Description
Content has been automatically translated.
I previously downloaded several models, but the filament was always too tight, and I was worried that AMSlite wouldn't be able to pull it, so I redesigned a replacement part for the official Bambu Lab spool
This model can 100% prevent AMSlite from being unable to pull the filament at the end
Please note
When starting to wind the filament, after passing it through the hole in the model, you need to secure it by winding it a few times in the hole of the Bambu Lab spool After it is fixed, you can wind the filament normally (as shown in the picture)
Recommended for printing with PETG
The print profile has been specifically optimized multiple times for PETG filament, resulting in excellent print quality
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (0)