Magnetic Collector for Screws & Nuts

Who doesn't know it? Once again, while crafting or repairing, a whole bunch of screws, nuts, or washers rolled onto the floor. The tedious, annoying manual collection is not only time-consuming but also drives you crazy

That stops now

This practical, magnetic collector makes picking up dropped small metal items a matter of seconds. Just roll it over and boom – everything sticks

You need 7 pieces of 5 x 2 mm magnets and some superglue

✨ Your advantages at a glance:

• Lightning-fast cleanup: No more bending and searching
• Lightweight & Turbo Print: The part weighs only about 18g and prints in under 1 hour
• Minimalist Design: Robust, functional, and quickly ready for use
• Easy Assembly: Only a few parts

🛠️ Assembly: Simple & rock-solid

Assembly is extremely simple and requires only little effort:

1. Press in magnets: The magnets are pressed snugly into their receptacles. For additional security and permanent hold, you can optionally use a drop of superglue
2. Fix the pin: Guide the pin with the tab from behind through the main part
3. Final assembly: Now put a drop of superglue into the receptacle for the pin and firmly press the parts together. Finally, apply a few dabs of glue to the edge of the lid and press it firmly into place as well. Done!

Please ensure that the edges in the lid and on the magnet holder are clean and smooth so that the part glides well afterward. If you are unsure, just go over it with some sandpaper.

Print this helper and focus again on what's important: your project – not the floor

👍 Free support: A like and a place in your collection show us that the CAD hours were worth it. ☺️