Search models, users, collections, and posts
Reolink E1 Pro Angled Stand - 2 versions (updated)
IP Report
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
1 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Scaled to fit the bigger E1 Pro / E1 Zoom
1.5 h
1 plate
Open in Bambu Studio
Boost
48
169
72
22
387
332
Released
Description
Simple stand to enable the Reolink E1 Pro camera to look down just a bit more. Two versions: a very simple and straightforward V1 and a slightly more sophisticated V2 where the camera sits a bit more snug with holes to route the power cable nicely. I use this to keep an eye on my laser engraver from the other room to make sure it doesn't burn down the house… ;-)
Note: The V2 version is just updated to v2a in an effort to accommodate the new camera version with the larger USB-C cable.
- Adding some small rubber feet is recommended to avoid unnecessary moving around.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (72)