Fruit fly trap round

I have now also created a round model of the fruit fly trap. It is filled with a piece of fruit or a vinegar/water mixture with a drop of dish soap to minimize surface tension. Ideally, ABS, ASA, etc. should be used as material. I personally always use PLA because I have nicer colors there :). These have still been sealed for over a week for me. I left only 0.10mm space between the container and the lid, but it can be opened and closed very easily. I noticed with the lid that the funnel gets a nicer surface if you print the walls from outside to inside. I have also set this in the profile. The bottom thickness is 3mm and is ironed. The entire model is printed with 100% infill. If you have any questions, feel free to write to me. Otherwise, have fun printing and fighting against fruit flies.