Bambu Lab P2S Ultra-Slim Poop Chute + Box

⚠️ IMPORTANT – PLEASE READ BEFORE PRINTING

I designed this ultra-slim poop chute because I wanted my P2S to sit as close to the wall as physically possible, and I couldn’t find any existing model that met my needs - so I made my own.

Even though it’s very slim, after six weeks of testing I haven’t experienced a single clog. The P2S produces relatively small waste pieces, which slide through the chute without issues.

The design is completely tool-free. No screws, no magnets, no extra hardware. Just hook it on and it sits securely in place.

The chute is also very lightweight — only 39 g with supports.

A small Bambu-style scrap box is included for anyone who wants a matching set.

NOTE:

I personally use a 90° power cable to push the printer as close to the wall as the buffer allows.

✅ Compatibility

Designed for Bambu Lab P2S

Community tested: confirmed to also work on Bambu Lab P1S

⚠️ Important printing notes

Ultra-slim design = intentional compromise.

This model prioritizes minimal depth. Very large purge / flush volumes may occasionally cause temporary stacking at the top of the chute.

Filament quality matters.

Brittle, wet, or low-quality filament can cause layer cracking or broken supports, and may also affect fit and  tolerances, potentially leading to print failure or extrusion pauses.

Supports are required (as indicated in the print profile).