Bambu A1 Poop Bucket & Scraper Holder (Clip In)

A Bambu A1 combined Poop Bin & Scraper holder which clips in place.

This is inspired by the great compact Poop Bin designed by Phio:

https://makerworld.com/en/models/647760-small-optimized-a1-poop-bucket#profileId-574271

However, I needed to create a version which clips in rather than using magnets, and I also needed to add a scraper holder.

The scraper holder I was using was excellent - https://makerworld.com/en/models/1030525-scraper-holder-a1#profileId-1013244 - however, I recently mounted a Wyze V4 camera - https://makerworld.com/en/models/472419-bambu-a1-wyze-cam-v4-base-mount#profileId-382241 - and unfortunately the scraper then obscured the Wyze V4 camera, so hence Fusion was booted up and this design came to be!

The model comes with a recessed 0.4mm Bambu Logo, and for those wanting slightly more bling, on Plate 2 there is a 1.2mm Bambu Logo that can be printed and then attached (as in the photos above).  This can obviously be printed in whichever colour you prefer, so it doesn't require AMS.

The model is clipped in place (small amount of pressure required) and thus provides stability (my setup vibrates quite a lot).  For removal, a slight amount of force is needed to remove.

Height:  88mm

Length:  207mm (208mm with Printed Logo)

Width:  90mm (109mm including Ramp)

Thickness:  1.75mm

Hope this proves useful for everyone!

WAIT!  THERE'S MORE…

If you like this model, why not check out some of my other Models.

https://makerworld.com/en/@Red27

    .