Search models, users, collections, and posts
Bora Centipede Tenons 20mm
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 50% infill
Designer
59 min
1 plate
Open in Bambu Studio
Boost
40
138
6
4
92
71
Released
Description
Content has been automatically translated.
I have a Bora Centipede frame for when I quickly need a workbench in the carport. The official tabletop was too expensive for me. Instead, I bought two MDF panels, 18mm thick and 67cm x 64cm. Both were connected with simple hinges, similar to the original, and 20mm holes were drilled in the corners (I believe the edge distance was 33mm). The printed tenons fit into the holes of the Centipede frame and the 20mm holes of the MDF panels. This prevents the tabletop from slipping. If something should “pop out,” I can still screw the tabletop to the 19mm holes of the Centipede supports (Rampa nut + knob screw).
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)