Hair dryer holder: Not limited to brands; Lifen, Xiaomi, Dyson, Kangfu, old-style large-headed hair dryers, and more can all be used

Newly Designed Hair Dryer Holder:

1. Tilt the hair dryer 45° for easy placement and retrieval
2. The holder itself supports most hair dryer models, except for high-speed ones, even older large-head heating coil models can be securely placed
3. No waste design, machines without nozzles can be used to hang hair ties, and the nozzle can also be left directly on the machine
4. Cord friendly, large curvature winding prevents cord end breakage
5. One-piece molding, high strength
6. Low cost, purely 3D Printed, no need to purchase magnets or hardware parts
7. Small size, supports A1 mini single plate printing
8. The model itself requires no supports and no embedded magnets to secure the nozzle
9. No tolerance fit requirements
10. Full curved design, user-friendly, and aesthetic
11. Equipped with a tray to efficiently utilize the space below
12. The tray's curved recess prevents small items from getting stuck when picking them up or putting them down

13. 0.24 layer height slicing to reduce printing time

    ✅PETG material tested and recommended for use

Precautions:

1. To avoid the risk of the device falling, it is recommended to use high-quality, non-thin-roll full sheet double-sided tape such as 3M 300LSE, cut to an appropriate size for adhesion; if conditions permit, a smooth build plate can be used

   1.1Update: Using nail-free adhesive is stronger than double-sided tape (⚠️Recommended)

   

2. Install M3*4 screws (iron) in the thread holes to enhance the magnetic feel when placing the nozzle (✅Not installing will not affect functionality)

   

3. For expensive hair dryers, silicone strips can be purchased, no size requirements (the picture shows 3mm thick, 10mm wide), cut and stick to the indicated position to improve potential wear that may occur from long-term use (✅Not installing will not affect functionality)

   

4. The print profile is for personally calibrated third-party PETG, it is recommended to slice it yourself and replace it with your own calibrated filament profile to achieve optimal printing quality (✅Recommended but not mandatory)

Other:

1. Theoretically, old-fashioned hair dryers can also be used, please try it yourself; if the head is too large or the handle is too small, it may not work, but the common type shown in the picture below is fine

   

2. The print profile for PLA filament requested by mobile users has been released ✅
3. The winding area has been tested and has sufficient strength; if it becomes brittle or breaks at the base of the tray when using poor quality filament, please leave a comment so I can add a modifier with a high infill version (attempting to improve, but final results are not guaranteed)
4. The hollowed-out version has received good feedback and can be printed ✅