Mounting bracket for ZWA-2 from Nabu Casa

You can find more holders for Nabu Casa devices here

_____________________________________________________________________________________________

Design
Unfortunately, the Nabu Casa Z-Wave adapter ZWA-2 no longer had a good spot on the shelf without being too close to other antennas So a wall solution was needed
I kept the design as compact as possible without sacrificing stability And while we're at it: a suitable version for the Multiboard System was also created

Variations
There are two variations each of the wall-mounted IKEA SKADIS and Multiboard versions
One variation requires a USB-C male-to-USB-C female 90-degree adapter so that the cable can be routed downwards Alternatively, you can also use a cable with a suitable angled connector
In the other variation, the USB-C cable is routed either to the right or to the left – depending on what best suits your setup
 

Assembly

• Wall
  The distance between the screw holes in the wall plate is 77 mm
  The screws I used are M4x30 mm, and the screw heads have a diameter of 7.8 mm
• Multiboard
  Mounting on the Multiboard wall can be done using this connection: 2-3x Big Thread Multipoint
  This ensures the adapter sits securely and can still be easily removed if needed
• IKEA SKADIS BOARD
  Simply print and hang

Print
I used PLA Basic from BambuLab – it works really great here
I set the layer height to 0.1 mm to avoid issues with the dovetail joint Additionally, this makes the surface a bit finer and more appealing
Support structures are only needed for the hooks on the IKEA SKADIS BOARD holder, but these are very small and easy to remove
 

Links

Wood screws Torx screws 4x30 *: https://amzn.to/4oxVjvr
Pan head screws Torx M4x30mm *: https://amzn.to/3Xuw7uY
USB C male to C female USB C. 90 degree adapter *: https://amzn.to/487S894
USB C data cable (90 degree angle)*: https://amzn.to/48rg2v5

Thanks to @DavidD for the Multiconnect System and Jonathan (KeepMaking) for creating multiboard

Updates:
06.01.2025
- Added IKEA SKADIS BOARD as a mounting method Thanks to @Leerzeichen  for the suggestion
- Expanded the rear cutout for the angled USB-C connector Thanks to @Cosmo q for the tip

Like this 3D model?

☕ Show your appreciation by buying me a coffee! 

👍 Share my creation and leave a comment below with any feedback or suggestions!

Note

All links with "*" are Amazon affiliate links. You are supporting my work at no extra cost to you.

All devices were purchased and paid for by myself.