Search models, users, collections, and posts
Short grabber (print in place)
GIF
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3 h
1 plate
Open in Bambu Studio
Boost
25
72
1
1
81
40
Released
Description
Profile is PETG but it should also print fine with PLA.
Just add a small rubber band per the picture (there's a small hook on the handle and the shaft) so the handle retracts.
If the the arms are a little stiff after printing just gently work them back and forth to loosen them.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)