Owl House – Skadis Mount for Echo Dot Kids
Print Profile(2)
Description
A decorative speaker house designed for the Echo Dot Kids.
Perfect for IKEA Skadis pegboards, kids’ rooms or gaming setups.
✨ Features:
- The speaker sits securely in its base.
- Side openings don’t just look good – they allow sound to pass freely and ensure the microphone isn’t affected during voice commands.
- Integrated cable routing and rear cable storage keep excess wiring clean and hidden.
🧩 Versions:
- Two-Part Model: Base and roof printed separately. They can be glued if desired. Ideal for multi-color results.
- Single-Piece Model: Printed in one go with integrated roof. Simple, sturdy, no assembly required.
➡️ If you want a simple holder without housing or extras, check out my model: IKEA Skadis Holder for Echo Dot Kids
⚠️Important notes:
I performed several print tests to achieve the best results.
The provided profiles delivered the best outcome on my setup – however print quality always depends on the combination of printer, slicer, and filament.
Initially, I encountered a slight layer shift between the base and wall transition (see image below) – this was resolved through tuning.
The following settings played a key role:
- Brim on the base recommended to prevent minor warping
- Reduced print speed for a more stable result
Flow ratio set to 0.96 (based on my filament: eSUN PLA+) ➡️ please adjust your settings if needed.
Remove supports carefully to avoid damaging the snap-fit hooks.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)