Search models, users, collections, and posts
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
368
912
208
82
2 k
1.3 k
Released
Description
The vinyl caps that I have had for different SMA connector radio devices I have were always falling off. I made these with the correct ¼-36 thread so that they stay on and don't fall off. Print with thin layers for the best detail on the knurling and threads. No supports needed.
BNC connector caps are now available as well! Get them here! https://makerworld.com/en/models/1074892#profileId-1065438
Boost Me (for free)
Any boosts are greatly appreciated!
sma male
sma female
sma connector
radio connector
fpv drone
fpv goggles
fpv remote
fpv
hackrf
wifi router
wifi
ham radio
hamitup
baofeng
handheld radio
radio cap
connector cap
sma cap
antenna
dipole
antenna mount
discone
amateur radio
ham
bnc
cb radio
uv5r
wardriving
flipperzero
flipper zero
dji
frsky
fat shark
receiver
heltec
shortwave
am radio
drone
dji drone
gopro mount
sw radio
ssb
meshtastic
uvk5
lilygo
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (208)