CPAP Tabletop Mask Stand

The original model is by “fathashome” on thingiverse which is linked as the original model to this remix.

I have formulated the build plates etc for a .3mf to be used on Bambu labs slicer.  The photos are from my own make showing my Airsense 11. Printed in black PETG on my A1.

from the original post:

"Made a self-standing mask & hose stand that can break down and fit in the carrying case for travel.

When traveling I hated laying my mask and hose wherever they would fit. They would always fall and collect dust and dirt. This is a freestanding hook that can break down and fit into the cpap carrying case so I can always have an organized bedside setup.

The hexagonal tubes allow for vertical layer lines so you won't have layer separation if too much weight is placed on it. I had make a slip ring with the layers going the opposite direction to help prevent splitting when fitting the tube onto the base or each other. I just glued the ring to the very bottom of the tube.

The base is sized to fit around the base of the ResMed Airsense 11 machine, but will probably work for a wide range of devices. The tube can be scaled in the ‘height’ direction to shorten or lengthen the height above the machine if needed.

Print Settings
Supports are needed just for the top of the tube that inserts into the other tube. I set from print bed only
I printed in PETG so I can use it while camping, PLA will work fine if it's not going to be anywhere hot"