Solder Fume Extractor

This fume extractor uses no screws or other hardware, except for a USB-C board and an 80mm fan. The extractor is very easy to assemble, as it consists of only 4 perfectly fitting parts

The extractor can be used with or without a filter. Without a filter, the extraction is naturally much stronger

The parts used:

Amazon:

USB-B Breakout Board:* https://amzn.to/48Z1DHO

80mm fan:* https://amzn.to/4oCENKN

Filter:* https://amzn.to/4iSZYHq

Aliexpress:

USB-B Breakout Board*: https://s.click.aliexpress.com/e/_c3hIK2vB

80mm fan*: https://s.click.aliexpress.com/e/_c3KqDdfR

Filter*: https://s.click.aliexpress.com/e/_c3xxIh3n

Instructions:

Step 1:

Slide the fan housing onto the base

Step 2:

Insert filter (if available)

Step 3:

Cut off the white connector of the fan cable and feed the cable through the hole

Step 4:

Insert the fan (pay attention to the direction) and place the cover on the housing

Step 5:

Pull the cable taut and cut it at 3cm

Step 6:

Solder the cables to the USB-C board

Red → VBus

Black → GND

Step 7:

Insert the board into the base. The cables must be bent to make space

Step 8:

Press in the small cover

*the marked links are part of an affiliate program through which I receive a small percentage of the sale