Search models, users, collections, and posts
Xiaomi Air Filter to 3D Printer Fume Hose Adaptor
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
3.5 h
1 plate
Open in Bambu Studio
Boost
2
10
1
0
4
1
Released
Description
Works with all Xiaomi air filters (outer Ø 200 mm) and 80 mm vent hoods.
I sealed the adaptor–hose joint with butyl tape (a bit extra 😅), but regular double-sided tape works fine too.
Note: most setups pull air from the side and exhaust upward, but this one is reverse flow — air enters through the center and exits from the side. The side exhaust feels gentle because the outlet area is large
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)