Mighty_Nug

cover

IMG_7156.jpg

CIB 2.png

CIB.png

plate_1.png

2025-12-14_5b747d0354841.png

<h3>Print Profile (Recommended)</h3>This model was tuned and tested using the following settings for sharp detail on the rifle, clean edges on the wreath, and a smooth top surface.Printer<ul><li>Bambu Lab P1S</li><li>0.4 mm nozzle</li></ul>Layer &amp; Quality<ul><li>Layer height: 0.20 mm</li><li>Initial layer height: 0.20 mm</li><li>Default line width: 0.42 mm</li><li>Initial layer line width: 0.50 mm</li><li>Outer wall line width: 0.42 mm</li><li>Inner wall line width: 0.45 mm</li><li>Top surface line width: 0.42 mm</li></ul>Walls &amp; Shells<ul><li>Wall loops: 2</li><li>Top shell layers: 5 (1.0 mm total)</li><li>Bottom shell layers: 3</li><li>Top surface pattern: Monotonic</li><li>Bottom surface pattern: Monotonic</li><li>Internal solid infill pattern: Rectilinear</li></ul>Infill<ul><li>Sparse infill density: 15%</li><li>Infill pattern: Triangles</li></ul>Speed<ul><li>Initial layer speed: 50 mm/s</li><li>Outer wall speed: 100 mm/s</li><li>Inner wall speed: 250 mm/s</li><li>Top surface speed: 50 mm/s</li><li>Sparse infill speed: 270 mm/s</li><li>Internal solid infill speed: 250 mm/s</li><li>Bridge speed: 50 mm/s</li><li>Slow down for overhangs: Enabled</li></ul>Seam<ul><li>Seam position: Aligned</li><li>Smart scarf seam: Enabled</li></ul>Supports<ul><li>Not required</li></ul>Material<ul><li>PLA recommended for best surface finish</li><li>PETG also works, reduce speeds slightly if needed</li></ul>Notes<ul><li>Prints cleanly as a single-color model</li><li>For multi-color prints, pause at layer changes or use AMS color swaps</li><li>Flat back is optimized for bed adhesion and display mounting</li></ul>

0.2mm layer, 2 walls, 15% infill

This project is a clean, print-ready Combat Infantryman Badge modeled for display or collection. The design follows the classic CIB layout with an infantry rifle over a rectangular bar, framed by an oak leaf wreath. Geometry is layered and balanced for clean edges and consistent depth when printed.Design details<ul><li>Raised rifle and border for clear definition</li><li>Oak leaf wreath with stepped depth for shadow and contrast</li><li>Flat back for easy mounting or display</li><li>Scaled to print cleanly without supports</li></ul>Printing notes<ul><li>No supports required</li><li>Prints well on standard 0.4 mm nozzle</li><li>0.16 to 0.2 mm layer height recommended</li><li>Works with PLA, PETG, or ABS</li><li>Looks good in single color or with color changes by layer</li></ul>Use<ul><li>Desk or shelf display</li><li>Wall mount</li><li>Shadow box or plaque insert</li></ul>If you want alternate sizes, a thinner profile, or a version split for multi-color prints, say the word and I’ll adjust it.

Combat Infantryman Badge (CIB) – 3D Print Model

ASIA

Print Profile(1)

Description

Comment & Rating (5)

License

Related Models