Swiss Scooter License Plate Holder
Print Profile(1)
Description
🇨🇭 Swiss Scooter License Plate Holder / Motorcycle License Plate Holder 🇨🇭
This 3D-printable license plate holder was specially designed for Swiss motorcycle and scooter license plates (CH standard)
It is a precise fit for the 3-point mounts, is compact and extremely stable, and suitable for permanent outdoor use on scooters and motorcycles
Thanks to its robust construction, the holder reliably keeps the license plate in place even with vibrations, wind, rain, and higher speeds
📏 Supported Swiss License Plate
- 180 × 140 mm (Swiss motorcycle license plate)
🛠 Recommended Print Materials
✔ PETG
✔ ABS
🖨 Print Settings (recommended)
- Wall lines: 3
- Infill: 100%
- Print speed: 100 %
- Support: not required
🔇 Vibration & Noise Damping (Recommendation)
To reduce vibrations, rattling, and buzzing of the license plate, it is recommended to:
- felt
- thick double-sided tape
- or similar damping material
apply to the back of the holder
👉 Significantly reduces metallic resonance, especially on uneven roads and at higher speeds
🔧 Mounting Instructions (IMPORTANT)
- Mounting via existing / original screw points of the vehicle
- Fasten with three screws directly to the rear apron
⚠️ ATTENTION:
Do not slide the license plate into the holder from the side!
✅ Correct Installation:
- Insert the license plate into the lower notches of the holder
- Press lightly downwards
- Firmly press the upper side firmly until the license plate sits neatly in the upper notch
🧩 Support
For questions, problems, or suggestions for improvement, you can contact me anytime via the comments
I will reply as quickly as possible and will be happy to help
If you have a problem with printing or assembly, please describe it briefly – ideally with pictures
🚀 Boost me
Boost Me (for free)
If you like the model and it helped you, I would appreciate:
⭐ Like
📷 Photo of your print result on the scooter / motorcycle
💬 Comment or feedback
🚀 Boost
This helps me to publish more free and high-quality models for MakerWorld
Thank you very much 🙏
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)