salsaia

cover

2024-03-01_yz9qnhtx5m8c.jpeg

plate_1.png

crate.webp

Screenshot 2025-03-30 at 5.36.34 PM.png

Solid Bottom - 0.2mm layer, 2 walls, 7% infill

tempImageGn54Gz_b6316423-bbb3-4ee6-a35a-1a2af7a22115.webp

Screenshot 2024-02-29 at 12.20.56 PM_96cdba4c-6b18-4ce7-8dd0-b3f2400ea59a.webp

plate_1.webp

Traditional Bottom - 0.2mm layer, 2 walls, 7% infill

fatReeG

att.UU3FTkpQdKD1cZwckaTcvV8W4tjFynAQs3DL1PcBsiY.jpg

Increased the distance between the crate and the hook - attaches very easily to boardShrunk the vertical length of the hook for easier insertion into board

Smaller Skadis Hooks, Bigger gap between model and hook

Tired And Hungy

Milk Crate 1.jpg

Milk Crate 2.jpg

Milk Crate 3.jpg

I scaled this model down very slightly (98.6% size) to make the pegs fit into my Skadis board much easier. &nbsp;0.2mm layer height, 2 wall loops, 7% gyroid infill. The outer wall and top face printing speeds are dropped to 60mm/s for printing with Bambu PLA Silk+, but if you&#39;re not printing with PLA Silk then just bump those back up to 250ish and it&#39;ll work fine. &nbsp;Make sure supports are enabled to tree (manual), if you choose tree (auto) then the software will go overkill and generate supports for every horizontal line it can see and uses 35g of filament for the supports, instead of the 1.5g it uses for manually painted supports.  Total print time was 3 hours 4 minutes and used 41.93g of filament. Hope this helps anyone who had problems with the pegs not fitting!

Slightly scaled down to fit pegs easier

Milk Crate

I created this remix so you can put a milk crate on your Skadis pegboard. There is an option with a solid bottom (smaller things won't falling through) and an option with a traditional bottom. The crate is 3.4in x 3.8in x 3in.Supports are only needed for the pegs.

Print Profile(4)

Description

Comment & Rating (638)

This remix is based on

License

Remixes (2)

Related Models

Skadis Milk Crate