Search models, users, collections, and posts
BentoBox v2.0 fan duct for Creality K1
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
3 h
1 plate
Open in Bambu Studio
Boost
10
15
1
0
18
1
Released
Description
It's a BentoBox v2.0 fan duct for Creality K1, inspired from this model https://www.printables.com/fr/model/641340-bento-box-v2-fan-duct-for-creality-k1
The goal is to mount the fan duct on the side instead of the back to improve the air flow inside the case.
Two longer screws BHCS are required (M4x10 or M4x12) to attach the model to the lower frame.
If the BentoBox is too close of the bed, you can use washers below the model.
I have connected the fans directly to the PSU. The BentoSwitch is optional.
You can find more information about the BentoBox v2.0 here :
https://makerworld.com/en/models/12786
---
If you like my work, don't hesitate to support me by paying me a ☕
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)