Search models, users, collections, and posts
26mm (1 inch) water pipe wall mounts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6.3 h
7 plates
Open in Bambu Studio
Boost
0
1
0
0
0
0
Released
Description
I have added the middle mounts if you want to have support on the middle. Personally, I WOULD NOT use this system without using the “wall mount 90 deg” because it is designed to be minimalistic and not to carry any load. But if you feel like it, please try. I would like to hear about the results if you do :D
Feel free to redesign the model. I would like to see the redesigns; therefore, it is put under (CC BY-NC) license.
Please Enjoy :D
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)