Plate Hooks for Chitu PlateCycler

I needed more plate hooks for the Chitu PlateCycler. Unfortunately, the file that Chitu itself published was not really printable, as it contained the model data of the original injection molded part.

Therefore, I remixed the Swapmod hook. It has become a bit wider, and there are also minor other changes.

The hook is simply attached with 2 M3x8mm screws and additional M3 nuts. If the holes are too tight, simply drill them out with a 3mm drill bit.

To mark the drill holes in the print plate, I recommend the Hole Alignment Tool on Printables by Chitu.