Can Opener for Soda, Beer, and other Beverages
Print Profile(5)
Description
Boost Me (for free)
If you enjoyed this model, boosts are greatly appreciated!
This is a can opener/helper, made for standard beverage cans such as soda, beer, sparkling water, cold coffee or tea, etc. I made this for my wife who occasionally struggled to open drink cans when her nails were done or otherwise prone to damage. It has a small divot to make the can opener feel more ergonomic. It prints in less 15 minutes and uses only roughly 2g of filament. Hopefully this helps you too!
12/27/25 [V1] - I updated the model slightly to improve strength and print quality, so if you had issues with the initial model please try again!
1/26/26 [V2] - I released a newer version of the model with a cutout to allow it to slide further over a can tab and be more stable. If you experience issues with can tabs bending, most likely it is because the can opener has not been pushed far enough. Use this version to make that easier!
If you're interested in other can opener models for different types of cans, check out my other models:
Thank you for checking out my model, and please leave any feedback or suggestions you have in the comments!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (288)