Hold with shelf support for HomeRacker

I have no idea if someone will need it, but here it goes.

For my custom prints I needed to add them to HomeRacker. I used shelf as base support. To connect my model I didn't want to glue it directly (so I can reuse the shelf later on), so I created these “supports”. There is a small wiggle room for some error.

Video why I made this model

You will need (for each):

Heat inserts for m3 and 3mm deep x1

M3 screws 5mm x1

How to use it:

• Put your 3d models on the shelf where you want it
• Add some painters tape to it
• Flip the shelf
• Mark cutouts on your model thru the shelf
• Remove the painters tape
• Print out the support count as needed
• Add heat inserts
• Glue the small supports on the marked places 
• Put it everything together with screws