Light bar for BRONCO SCX30

I made a modification to the light bar allowing it to be mounted on BRONCO SCX30

By removing the slotted roof attachments and incorporating 2 replicas of the hole covers that Axial provides in the BRONCO kit into the design.

It installs in place of the 2 hole covers that are used when removing the original roof rack, using the same screws you would normally use to fasten them.

IF you have difficulty inserting them, loosen the screws a bit, then press the bar while tightening the screw, slowly you will see that it will pull itself into the slot

I printed it with a 0.08 layer and a 0.4 nozzle, surely with a 0.2 nozzle it will be better and more resistant.

DO YOU LIKE MY MODEL? I ALWAYS SPEND TIME AND DEDICATION TO CREATE THE FILES

IF YOU LIKED IT, LEAVE YOUR MARK!

THANK YOU