Saeco Gran Baristo drip catcher

🇪🇸 Spanish

Tired of cleaning the main drip tray every time the machine rinses? I designed this accessory specifically for the Saeco GranBaristo with efficiency in mind. This small container collects water from auto-cleaning cycles and residual coffee drips, preventing you from having to constantly disassemble and scrub the large metal tray.

Key design points:

• Fast Print: Ready in approximately 1:15 hours.
• Zero Supports: Optimized geometry for direct printing on the bed without material waste.
• Modular Feet: The lower "feet" are printed separately to avoid complex bridging. They serve to fit or stabilize the container on the grid.
• Lightweight and Functional: Thin but resistant walls.

Assembly Instructions: The model consists of the main body and the feet.

• If you print in ASA/ABS: You can join the feet using acetone for a perfect chemical weld (as I did).
• If you print in PLA/PETG: A few drops of cyanoacrylate (Superglue) are sufficient.

🇺🇸 English

Tired of cleaning the huge main drip tray after every rinse cycle? I designed this custom catcher for the Saeco GranBaristo to keep your machine maintenance low. It catches all the auto-rinse water and coffee drips, so you don't have to haul the heavy metal tray to the sink every day.

Key Features:

• Fast Print: Takes about 1:15 hour with standard settings.
• No Supports Needed: Designed to print clean with no waste.
• Modular Feet: The bottom feet are printed separately to ensure a perfect surface finish. They stabilize the cup on the metal grill.
• Lightweight & Efficient.

Assembly:

• For ASA/ABS users: Use acetone to chemically weld the feet to the body.
• For PLA/PETG users: Standard superglue works perfectly.