Giant Nut & Bolt
Print Profile(3)
Description
This set is a great statement piece! Although not intended for actual use, they are sized properly to meet standards for an M64 nut and M64x150 bolt (ISO4032 & ISO4762 respectively). I have also included the proper allen key (46mm) needed to install the bolt. The allen key has 3 main components, along with 2 pins to hold everything together:
- Section 1 - Tool End
- Section 2 - Middle Piece
- Section 3 - Ball End
- Pin - Print twice
Please see the assembly instructions below.
Print Settings
All pieces print fine without supports or any special settings. For best print results, print all pieces in the orientation as they come. Although not required, I reduced infill in most areas. However, I used a higher infill percentage below all top surfaces.
Allen Key Assembly
The following filament was used in the pictures above:
- Bambu Lab Matte Charcoal PLA
Membership
Are you looking for a Commercial License for all JamesThePrinter models?
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (384)