Mini-Domino Crossing with integrated pins

As a domino fan, I created this small mini crossing, where the pins are also printed directly integrated. This means both sides have flat surfaces, so it doesn't matter from which side the line comes

The only drawback is that this mini version tends to slide, so it should be glued to the floor

For this, I recommend UHU Pattafix adhesive dots. These provide grip but allow easy removal of the crossing from the floor without damaging the part

UHU Patafix, 148 reusable adhesive pads for clean fastening of posters, photos, decorations in school or office, 148 pieces : Amazon.de: Commercial, Industrial & Scientific

But with this mini version, you save even more space and can cross two lines without a bridge

Feel free to try out this model, let me know if you have any suggestions for improvement, and rate my design

Otherwise, feel free to check below, as I have created more models, as well as a large crossing. Maybe you'll like a few things there too

MORE MODELS

I have created more models for domino fun. Feel free to check them out, maybe there's something else you could use

DOMINO LINE SAFETY BARRIER

Domino Line Safety Barrier – Free 3D Print Model – MakerWorld

With this, you can build in individual safety features in between when you are building larger and longer projects and want to minimize the risk

DOMINO STAIRS

Domino Stairs – Free 3D Print Model – MakerWorld
With these stairs, you can bridge other lines and build cool angles. It also helps to make use of the space in your apartment. The domino stairs have plates of different widths that can be placed on top, so one or two lines can be bridged

DOMINO STAIRS WITH ANCHOR

Domino Stairs with Anchor – Free 3D Print Model – MakerWorld

If the normal stairs are cumbersome for you because the top plates are loose, I have designed stairs with an anchor. The top plate hooks into the stair treads and sits firmly. Nothing can slip, and you can even align the stairs more easily for building. Here too, there are top plates of different lengths

DOMINO CROSSING

Domino Crossing – Free 3D Print Model – MakerWorld

If you find the bridges too large, for example, because you want to cross lines in a very small space, there is another option, namely the crossing. The part is placed exactly in the middle of both lines, and the pins push the line on the other side, without a bridge being used or the other line being accidentally pushed

DOMINO “DC” DIRECTION CHANGER

Domino "DC" Direction Changer – Free 3D Print Model – MakerWorld

This direction changer allows you to change the direction of the line in a small space. You don't need to build curves, which consume dominoes and are also a error factor, because if the curve is not built correctly, the line can stop. This DC is an ideal replacement

MINI DOMINO CROSSING

Mini Domino Crossing with Integrated Pins – Free 3D Print Model – MakerWorld

This mini domino crossing is much smaller, so it disappears better between the lines. The pins are also directly integrated, so they cannot fall out. This way you can cross two lines in an even smaller space without bridges

DOMINO SLIDE

Domino Slide – Free 3D Print Model – MakerWorld

Why always stairs? I asked myself the same question and instead designed the domino slide. It is compatible with the domino stairs I designed, so it can replace a stair or even be used as the start of a line. This way you can use it in many ways

MINI DOMINO “DC” DIRECTION CHANGER

Mini Domino "DC" Direction Changer – Free 3D Print Model – MakerWorld

This DC is even smaller, allowing the lines to stand closer together. This way, tight curves that are very likely to fall can be replaced

I would be very happy if you look at the other parts, perhaps print some, and give me feedback so I can improve them

From time to time, new parts or improvements will follow, so feel free to follow me so you don't miss anything