Ice Cream Cone Drip Shelf

A shelf that looks like it’s mid-melt.
Not the fastest print, not the least waste — but absolutely worth it.

• A decorative wall shelf designed as a single, continuous ice-cream-cone form
• The “drip” top and cone are intentionally one solid structure for strength
• Built to actually function as a shelf, not just hang there looking pretty
• Designed for clean geometry, consistent layers, and predictable strength
• Originally designed for my own wall — shared because others asked for it

This wasn’t designed to win efficiency awards. It was designed to look right, print reliably, and hold weight like a shelf should.

• Printer compatibility: Any standard FDM printer with adequate build height
• Nozzle: 0.4 mm
• Orientation: Print exactly as provided
• Supports: None
• Multi-color / AMS: Yes, this uses AMS and generates purge waste

About the waste.. Read this before print!!

Yes — this print creates purge waste.
Yes — it takes a while.

I don’t like waste either. I actively design to reduce it whenever possible.
In this case, splitting the model compromises strength, alignment, and the visual flow of the drip — all things that matter for a load-bearing shelf.

Could it be split? Sure.
Should it be, if you care about structure and finish? In my opinion: no.

ASSEMBLY / MOUNTING

• Designed to mount directly to the wall
• Use appropriate wall anchors or studs depending on load
• If mounting into drywall only, do not overload it
• This is décor + light utility, not a gym shelf

Mount it like you would any small decorative shelf and use common sense.

MINI FAQ

Q: Can I split this to reduce waste?
A: You can remix it if you want, but the provided design is intentionally one piece for strength and appearance.

Q: Does it really need AMS?
A: Yes, if you want the two-color look shown. Single-color prints work too.

Q: Will you upload a split version later?
A: No plans at the moment.