Search models, users, collections, and posts
Retro Bills Standing Buffalo
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
9
24
2
0
21
18
Released
Description
This is a model of the Buffalo Bills standing buffalo without an insert for a chain. It should look great on your desk or even hanging on a wall using a good adhesive tape.
I do intend to make a stand that will allow the Buffalo to not fall over as easily in the near future.
It is approx 232x172.8x13. It takes approximately 2 Hours and 10 minutes and uses 109 grams of filament. 68 White and 41Red.
Boost Me (for free)
Feel free to leave a Boost if you feel so inclined. Thanks for downloading and hope you enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)