Search models, users, collections, and posts
Sticker Roll Holder/Dispenser & Base(s) for 50 mm
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
12.7 h
4 plates
Open in Bambu Studio
Boost
33
119
7
1
144
83
Released
Description
Boost Me (for free)
If you like what you see, please consider boosting, it helps to promote morale and confidence it our makers! Thanks :)
A remix of the model by Chonky Creations
I needed it to fit 50 mm round stickers this was the best option for them, works amazing such a simple and neat design, see original here.
- Adjusted to fit sticker rolls up to around 50 mm.
- NO SUPPORTS REQUIRED - other than for the top base if you choose to print that
- kept the original top and bottom bases from the og design
- May need a bit of blue tack or similar to keep the lid in place.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)