Search models, users, collections, and posts
Remixed - BambuLab X1/P1 A1 Mini Nozzle Wiper
Remixed by
IP Report
Print Profile(2)
ASA - 0.2mm layer, 2 walls, 15% infill
Designer
25 min
1 plate
PETG-HF 0.16mm layer, 2 walls, 15% infill
31 min
1 plate
Open in Bambu Studio
Boost
429
1028
208
69
2.3 k
1.2 k
Released
Description
Here's what's different between this one and the original
- 2 screws instead of 3
- 1 part instead of 2
For the Cover:
https://makerworld.com/en/models/177297#profileId-209102
Notes:
- I have noticed that at times a bit of filament gets stuck between the brush and the ptfe wiper, it seems to only happen after the print has finished, so I am assuming that it's on the last filament unload, just remember to check and clear it.
I have been using it for a day or so with not issues, note I did print mine in ASA
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (208)